Adding Zonal Controller CUC-14RR and Ultrasonic Detector in DMS

1, If using Ethernet to connect the zonal controller. If the RS485 to ethernet convertor have been set and connected. The IP and port shall be filled in the actual convertor IP and port.

According to the zonal controller and the ultrasonic detector it loads to add the corresponding element in the DMS ultrasonic module.

2, If using RS485 to connect the zonal controller. Then add equipment and fill in base on actual. The factory default IP for RS485 linking is also 127.0.0.1

Address and port please also fill in actual.

PORT is determined according to the connected COM port. It will be 48505, 48506, 48507 or 48508).

Adding Parking Space and Binding Ultrasonic Detector in MPGS

1, Open the Map Edititor. Follow the following step to add the parking sapce element in the map.

Please notice to click the Fixed(Blank Space) and Unlock(L) buttons and make them green.

Then click the Parking Space button and click in the map to add the space.(Not dragging)

2, You can adjust the parking space element direction or size as your wish.

Type in the Parking Space Number and also click the button of Bind Device.

Type in the Zonal Controller ID+Detector ID in the box.(For example: zonal controller 12, sensor address 12, then type in 1212) .Then save the map.

If you click the first parking space and then copy, it will automatically generate next parking space. The parking space number will increase, but you will still need to fill in the controller and detector ID information.

3, You can see the parking space stutus in the map.

4, You can all see the ultrasonic detector stutus in the device status of MPGS.